ep

January 22, 2021

SMR Gearbox Set up
Satisfactory overall performance is determined by suitable installation. lubrication and upkeep. consequently it is necessary the directions during the installation and maintenance leaflet. supplied with each gearbox. are followed very carefully. some of the crucial elements of belt and torque-arm installation are listed under.
1. Install pulley on gearbox input shaft as close for the reducer achievable, and mount reducer on driven shaft as shut to bearing as practical. failure to do this can lead to excess loads inside the input shaft bearings and output bearings and could bring about their premature failure.
two. Install motor and wedge belt drive with all the belt pull at roughly 90° towards the center line in between driven and input shafts. this will permit tensioning of the wedge belt drive with the torque arm which ought to ideally be in tension. if output hub runs anti-clockwise. torque arm should be positioned the correct.
3. lnstall torque-arm fulcrum on a rigid support in order that the torque-arm will be at about suitable angles towards the center line through the driven shaft along with the torque arm case bolt. make sure there is certainly enough take up within the turnbuckle for belt tension adjustment.
Keep near.
Bell drive can be found in any practical postion. should the torque arm is always to be made use of to tighten the belts, the drive ought to be at about tight angle for the line in between the input and output shafts.
Bell drive might be located for the proper if sought after.
If output hub rotates clock-wise. place belt drive and torque arm in opposite course to that proven from the illustration.
Torque arm and belt take up.
Torque arm could be mounted towards the suitable if sought after.