Power UNITS FOR LIFT TABLE one
General Description
This power unit is created exclusively for that small lift table,Consisting of high pressure gear pump, AC motor, multi-functional manifold, valves, tank, etc. This energy unit is broadly employed from the marketplace of logistic products such as minifork lift, scissors lift and ariel working platforms. The lower-ing motion is controlled through the solenoid valve with all the speed managed through the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
Standard Description
This power unit is developed solely for the medium lift table, Consisting of hugely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve along with the speed controlled by the adjustable needle valve. Once the lift rises to a substantial positoin, but the electrical power supply is minimize, the lowering movement is controlled by the manual override function.
Energy UNITS FOR LIFT TABLE three
Standard Description
This power unit is created exclusively to the large lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived by the solenoid valve and also the pace managed by a stress compensated flow control valve.
Power UNITS FOR LIFT TABLE 4
General Description
This electrical power unit is designed exclusively for your significant lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve as well as pace controlled from the adjustable needle valve. Once the lift rises to a high positoin, but the power supply is cut, the lowering movement is managed by the manual override perform.
Distinctive Notes
1. This energy unit is of S3 duty cycle, which could only perform intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean the many hydraulic components concerned just before installation of the power unit.
3. Viscosity in the oil shoud be 15~46 cst,which ought to also be clean and absolutely free of impurities.N46 hydraulic oil is advised.
four. Oil shifting is needed just after the initial 100 operation hrs,afterwards after just about every 3000 hours.
five. The energy unit proven is created to be mounted vertically.